Bosch 2 608 000 690
Manufacturer-mapped 150 mm pad saver for the GET75 family.
Bosch prints the part number beside GET75-150 in its current manual and identifies it as a punched 150 mm pad saver.
Evidence note C065 · United States
The US tool name uses inches; Bosch’s current international accessory map uses millimeters. The exact part number joins the two more safely than “generic 150 mm.”
Direct answer
The US GET75-6 uses a 6-inch (150 mm) hook-and-loop backing pad. Bosch’s current GET75-150 manual maps pad saver 2 608 000 690 to that 150 mm model, and Bosch’s accessory page describes the same number as a punched 150 mm pad saver for mesh abrasives. This is a thin hook-and-loop protection interface, not the backing pad itself.
Decision map
Family resemblance is not compatibility evidence. Each row stops exactly where the cited source stops.
Manufacturer-mapped 150 mm pad saver for the GET75 family.
Bosch prints the part number beside GET75-150 in its current manual and identifies it as a punched 150 mm pad saver.
Diameter alone is not enough.
Perforation, hook strength, thickness and exposure of the multi-hole dust channels can differ.
These are different parts.
The saver is a sacrificial hook-and-loop interface; the backing pad is the structural driven pad.
Before buying
Match the Bosch identifier 2 608 000 690 (often written 2608000690) and 150 mm size.
Confirm the item is a thin punched pad saver, not a 150 mm backing pad or edge guard.
Place it between the backing pad and abrasive with the perforations exposing the pad’s dust channels.
Disconnect the tool before changing accessories and replace any interface that will not stay flat or centered.
Primary evidence
Evidence boundary
Bosch names the US tool GET75-6 and the current international 150 mm model GET75-150. This page uses Bosch’s shared 150 mm model/accessory mapping; it does not certify an unlabeled third-party copy or guarantee current US retail stock.